Product Overview

The Motorcycle Control Module is an electronic actuator controller that regulates throttle or mechanism position according to operating load. It is used in generators, small-engine equipment, and vehicle auxiliary systems that require automatic position adjustment and remote firmware management.

Key Advantages

24BYJ48 Stepper Motor with 1/16 Gear Ratio

The integrated 12 V geared stepper motor provides repeatable incremental movement for throttle levers and small actuators. Under changing generator load, the 1/16 reduction helps maintain controlled position changes instead of abrupt manual adjustment.

Below 15 mA Standby and Below 1 mA Low-Power Current

When the engine or generator remains idle, current consumption falls to a level that limits battery discharge. The module can stay connected in equipment that is parked between work cycles without requiring a separate disconnect routine.

BLE 5.0 OTA Update with Automatic Rollback

Firmware can be updated through Bluetooth without opening the enclosure. If an update is interrupted, rollback restores the previous version, preventing an incomplete field update from leaving the controller unusable.

Key Specifications

Parameter	Value
Stepper motor	24BYJ48, 12V, 1/16 ratio
Input voltage	DC 12V ~ 25V
Standby current	< 15 mA
Upgrade	OTA (BLE 5.0)
Size	80.4 x 61.2 x 22 mm

Customization Capabilities

Actuator and Control Parameters
Motor model, gear ratio, movement range, step sequence, speed curve, position limits, and load-based control logic can be matched to the throttle or actuator mechanism.

Bluetooth and Firmware Definition
BLE commands, pairing method, application communication, OTA package structure, fault codes, and recovery behavior can be configured for the equipment controller.

Housing and Wiring Interface
Mounting points, enclosure outline, antenna position, connector, pin assignment, cable length, and label content can be matched to the control box.

Quality Control

Actuator Calibration
First pieces are run through the approved step sequence under representative actuator load. Direction, travel limits, position repeatability, and return behavior are confirmed before production settings are locked.

Firmware Update Recovery
BLE pairing and command response are checked with the approved application. The OTA package is installed, and an interrupted update is used to confirm automatic rollback to the previous firmware.

Production Release Inspection
Patrol and final checks cover connector seating, antenna position, enclosure fit, power-on response, and programmed movement. The approved hardware and firmware versions are confirmed before packing.